Air Entrainment Meter
UTC-0650
The air content of fresh concrete can be determined by using the Air Entrainment Meter. It has a quick action clamping system. Direct pressure gauge reading to the nearest 0.1% up to 6% air and 0.2% from 6 to 10% air. The meter is not affected by changes in the barometric pressure.
The meter measures values up to 22% entrained air. It is appropriate for aggregate sizes of a maximum 63 mm.
Testing Method
The pressure method is used to take measurements of air content in fresh concrete. The total volume occupied by a fixed amount of air is determined by how much pressure needs to be applied. The test method with the meter is as follows:
- A fixed volume air chamber is pressured to a set operating pressure
- A valve is opened between the air chamber and the concrete sample chamber equalising air pressure between the two. The greater the volume of air in the concrete the higher the pressure drop will be
- The pressure gauge will then display the amount of air content.
This method is not intended for use where concrete is manufactured with light weight aggregates.
Components
The Air Entrainment Meter is supplied complete with:
- Testing Vessel
- Flanged 7 litre capacity cylindrical vessel and cover assembly incorporating pressure gauge, air pump and valves.
- Straight Edge
- Tamping Rod
- Wash Bottle
- 250cc J-Type pipe and an inner extension pipe for calibration
- Carrying Case
Standards
- AS 1012.4
- EN 12350-7
- ASTM C231
- AASHTO T152
Specifications
| Model | UTC-0650 |
| Capacity | 7 Litres |
| Air Content Range | 0-10 % |
| Graduations | 0.1% up to 6% / 0.2% from 6%-10% |
| Dimensions | 300 x 310 x 610 mm |
| Weight | 16 kg |
Air Entrainment Meter for Mortar
UTCM-0666
The UTCM-0666 Air Entrainment Meter for Mortar is used for determining
the air content of cement paste, cement mortar and lime mortar. The air entrainment meter is manufactured from cast aluminum, the upper part and the lower test pot are held together with an air-tight seal which are easily adjusted by using the two spring clamps. The pressure gauge is installed in the head of the meter and the scale works in the 0-20 volumetric % range. The air is compressed with a hand pump installed in the system and the smart configuration of the test and correction buttons enables fast and simple testing.
Specifications
| Dimensions | 200 x 200 x 320 mm |
| Weight (approx.) | 3.5 kg |
